Titebond Adhesive Remover Cleaning Wipes are formulated to remove a variety of adhesive and sealant technologies including solvent-based, advanced polymer, urethane, water-based and polyvinyl acetate (PVA) adhesives. The wipes can be used for clean up on a variety of different surfaces and applications, including most pre-finished (...


Watch Video

Features & Benefits

Easy-to-use wipes
Pre-soaked towels
Removes many adhesive types
Powerful organic formula

Application Guidelines

For Use as a Urethane Release Agent:
Wipe finished surface (top) of each board with Titebond Adhesive Remover wipes prior to spreading urethane glues to ensure easy clean-up of urethane adhesives on finished wood floors. Be sure to thoroughly wash the newly installed floor once installation is complete to remove remaining adhesive remover. CAUTION: Floor will be extremely slippery with remover residue on the wood surface
For General Adhesive Removal:
  1. Pull off container cover and remove and discard seal. From the center of the roll, pull up a corner of a wipe, twist to a point and thread through the hole in the underside of the cover. Replace cover tightly. Pull towel through dispensing hole and tear at perforation. Close snap-down lid to keep towels from drying out when not in use.
  2. Rub area of floor that has wet or cured adhesive with a cleaning wipe in a slow circular manner. See “USER TIPS” on label for more information.
  3. If adhesive has cured for more than 48 hours, lay a towel over the cured adhesive and let stand for approximately five minutes. Wipe area clean with a fresh towel to remove excess adhesive and repeat.
  4. Once you have cleaned the affected area with a cleaning wipe, wipe the area with a clean, water-dampened cloth to remove any remaining remover.
If you are cleaning a floor surface, clean the affected area with a cleaning wipe; wipe the area with a clean cloth and a pre-finished floor cleaner to completely remove any oily residue and to prevent slipping.
Be sure NOT to scrub the surface too aggressively as this will change the look of the finish, particularly with floors. Do NOT allow excess remover to drop between floor boards. Close cap when wipes are not in use. Store this product in a clean, dry area. For additional questions or recommendations, please contact Technical Service at 1.800.347.4583 or visit us at Titebond.com.

Physical Properties

Calculated VOC
14 g/L
Citrus odor
200°F (94°C)

Caution Statement

CAUTION: WARNING. Causes skin and serious eye irritation. Wear eye protection, protective clothing, protective gloves. Wash hands thoroughly after handling. FIRST AID: Never give anything by mouth to an unconscious person. If you feel unwell, seek medical advice (show the label where possible). IF INHALED: Remove to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or doctor/physician if unwell. IF ON SKIN: Immediately rinse with plenty of soap and water (for at least 15 minutes). Take off contaminated clothing and wash before reuse. If irritation persists: Get medical advice/attention. IF IN EYES: Rinse immediately and thoroughly, pulling the eyelids well away from the eye (15 minutes minimum). Remove contact lenses if present and easy to do so. If eye irritation persists: Get medical advice/attention. IF SWALLOWED: Rinse mouth, Do NOT induce vomiting, Obtain emergency medical attention.

Dispose of contents/container to licensed waste handling facility. For additional information, refer to Safety Data Sheet.